1983_Recovery of KCL KSO4 and Boron From Atacama Brines--Paper_Pavovic-Zuvic et al.pdf

Sixth International Symposium on Salt, 1983—Vol. II Salt Institute Recovery of Potassium Chloride, Potassium Sulfate and Boric Acid from the Salar de Atacama Brines Pedro Pavlovic-Zuvic, Nancy Parada-Frederick and Luis Vergara-Edwards Comitó de Sales Mixtas—CORFO Santiago, Chile ABSTRACT A solar evaporation process has been designed for the extrac- tion of potassium chloride, potassium sulfate and boric acid from the brine deposits of the Salar de Atacama in northern Chile, The brine will be c
of 18
All materials on our website are shared by users. If you have any questions about copyright issues, please report us to resolve them. We are always happy to assist you.
Similar Documents
  Sixth International Symposium on Salt, 1983—Vol. II   alt Institute Recovery of Potassium Chloride, Potassium Sulfate and Boric Acid from the Salar de Atacama Brines Pedro Pavlovic-Zuvic, Nancy Parada-Frederick and Luis Vergara-Edwards Comitó de Sales Mixtas—CORFOSantiago Chile ABSTRACT A solar evaporation process has been designed for the extrac- tion of potassium chloride, potassium sulfate and boric acid from the brine deposits of the Salar de Atacama in northern Chile, The brine will be concentrated in a series of ponds. A se-quence of three stages was defined for the crystallization of ha- lite. sylvinite and mixed sulfate salts, containing schoenite, kainite and lithium-potassium sulfate. Potassium chloride is produced by flotation of the harvested sylvinite salts, Potassiumsulfate is obtained from the harvested mixed sulfate salts. Boricacid is recovered by acidification from the end brines of the sul-fate ponds. The harvested halite is discarded. The Chilean Development Corporation ICORFO has sup- ported the development of a project to produce 520,000 tons peryear of potassium chloride. 150,000 tons per year of potassium sulfate and 30 000 tons per year of boric acid. The project design and the economic estimates will be presented here. INTRODUCTION The high evaporation rates and minimal rainfall at theSalar de Atacama in northern Chile make it possible touse solar evaporation ponds to concentrate the brines of this large salt deposit. The phase chemistry studies of evaporating brines have demonstrated that it is possible to recover potassium salts from the mixed salts. In a series of ponds the sequence of salt crystallization is halite, sylvinite and sulfate salts. The potassium salts to be produced are potassium chloride and potassium sulfate. The raw materials are harvested salts from the sylvinite and sulfate ponds, re- spectively. Boric acid will also be recovered from the end brines of the sulfate ponds. Lithium production was not considered in this process design. It was found experimentally that weather conditions alter both the quantity of the solar deposit and composi- tion of the mixed salts that crystallize in the solar ponds.Therefore, the evaporation process design considers two different end brine compositions for each evaporation stage; one for summer (September to March) and the other for winter (April to August).The production of potassium chloride from sylvinite isa well known process and can use technologies proven in commercial operations. Flotation is the most important method of separating sylvite from the sylvinite. The saltone used by Great Salt Lake Minerals & Chemicals the U.S.A. to produce potassium sulfate. This similar- ity allows an analogy to be made with their operation. However, the lithium content in the harvested sulfate salts has to be adjusted in order to use the Great Salt Lake process. The boric acid production by acidification of the final concentrated brines also has some industrial precedent from a previously employed operation at the Chilean nitrate industry.Experimental work was carried out to demonstrate the feasibility of producing KCI and K 2 SO 4  from the solar evaporation salts, and I-1 3 130 3  from the end brines of the pond system. The steps involved in the commercial opera- tion (Figure 1) are the following: ã Pumping of brines from production wells to solar evaporation ponds ã Concentration of brines in solar ponds and harvest- ing of the crystallized saltsã Production of potassium salts and boric acid in chemical plants.A chemical complex to produce annually 520,000 tons of KCI, 150,000 tons of K 2 SO 4  and 30,000 tons of fi 3 f10 3 was evaluated.  77  378   Sixth International Symposium on Salt 1983—Vol. II S S AR DE ATACAMA BR1NEF1ELD   BRINE 31 200.000 T/ Y HALITE SYLVINITE SULFATE SOLAR PONDS PONDSPONDS PONDS 8 2 km2 3 9 km2/ 9 km2 FINAL CONCENTRATED BRINE ãi  HALITE SYLVITE SCHOENITE HALITEKAINITE SCHOENITE CARNALLITE,Li K SO4 ,HALITESYLVITE HARVESTED CRYSTALLIZED SALTS POTASSIUM POTASSIUM BORIC CHEMICAL PLANTS CHLORIDE SULFATE ACID PLANTPLANT PLANT FINAL PRODUCTS KCI 520,000 1 - /V K 2  SO 4 150,000 T/Y H 3 80 3 30,000 Tr   Figure 1. General flow diagram of a chemical complex to produce potassium salts and boric acid at the Salar de Atacama PROCESS DESIGN Brimfield. Pumping tests performed n the Salar nu- cleus allow a brine well design based on flow of 30 I/sec. According to the plant sizes selected, the feed require- ment to the solar ponds is about 31.2 million tons/year of brine. This represents an annual average flow rate in the order of 800 1/sec. Nevertheless, a higher flow is needed to meet summer evaporation rates plus the requirementsduring peak filling operation. Forty production wells,which would be 16 diameter holes drilled down to 30 meters, will be necessary. The brine delivery system will consist of a single pipe- line with booster pumps extending 25 kilometers from the brinefield toward the pond area. Concentration of Brines in Solar Ponds. Experimental studies carried out in the field with small metal pans has provided basic information on evaporation rates and the  Recovery of Potassium Chloride, Potassium Sulfate and Boric Acid   379 phase chemistry of the Salar de Atacama brines. This in- formation was used to define the number of stages in an evaporation process for the extraction of potassium salts,and to calculate the area of the pond system. Brine pumped from the production wells will be con-centrated in three groups of solar evaporation ponds. Inthe first, sodium chloride is crystallized during concen-tration to potassium saturation. The brine is then trans- ferred to a second group of ponds where a mixture of hal-ite and sylvite, with some schoenite, crystallizes. Further evaporation in a third group of ponds crystallizes potas- sium in the form of kainite, schoenite, potassium-lithiumsulfate, potassium chloride and some carnallite, together with sodium chloride. The salts harvested from all theseponds, except the halite, will be transported to chemical plants to be processed.The potassium content in the starting brine is about 1.8 per cent. The enormous amount of water which must beevaporated would make the process uneconomic were it not for the possibility of using solar evaporation. Further- more, the occurrence of good quality clays on the northside of the central nucleus of the Salar permits the con- struction of large, inexpensive solar ponds. An estimated total pond area of 14 km 2  is required to evaporate about18 million tons per year of water to recover the desired tonnage of products. It is important to remark that the utilization of solar energy to evaporate all this water would save approximately 1.8 million tons/year of Fuel Oil N° 6. Solar Pond Harvesting. The ponds will be harvested after the desired crystallized salt has formed a 0.30- metre-thick layer over a previously formed protective saltfloor base (0.30 m). The harvesting operation will consistof first draining all superficial solution from the pond andthen trenching the salts for drainage. The harvesting sys- tem selected will be similar to the one used in the solar salt industry, where a specially designed harvester removesthe salt from the floor, conveys it and loads a truck run- ning with equal speed alongside the harvesting machine.Different equipment may be required for the mixed salts. Additional study will be necessary for the final design. Auxiliary equipment (motor graders, bulldozers, front- end loaders, etc.) will be used to windrow the salt, and for cleanup and bottom smoothing. The meteorological con-ditions at the Salar de Atacama allow harvesting through- out the whole year. Sodium Chloride Production. The first group of pondsis used to crystallize approximately three quarters of thesodium chloride present in the brine. The halite salts willbe harvested and discarded. The brine density changes from 1.226 to 1.262 g/cm 3 in this stage, crystallizing approximately 330 kg of so- dium chloride per 1,000 kg of evaporated water. Chemical analyses of crystallized salts in test pans have shown that in the halite stage potassium precipitates earlier in winter. To minimize the potassium losses dif-ferent end brine compositions were defined for summer and winter, as indicated in Table 1. Therefore, the crystallized salts in the halite ponds are practically pure sodium chloride. Potassium Chloride Production. The sylvinite salts harvested from the second group of ponds will be the raw material for the potassium chloride plant. The type of salts that crystallize in these ponds are slightly different for the summer and winter. For this reason, the end brinecompositions were defined to avoid the crystallization of lithium as KLiSO 4  in summer and to keep the crystalliza- tion of schoenite in winter as low as possible. The average composition for these brines and salts are presented in Table 2. In the sylvinite ponds about 60% of the entering potassium will crystallize. For each 1,000 kg of evapo- rated water over 450 kg of salts precipitate. Potassium chloride crystallizes together with sodium chloride as a salt mixture called sylvinite. The process torecover potash from this salt is well known and involvesthe flotation of the sylvite from the sylvinite. A schematic flow diagram is shown in Figure 2. The sylvinite salts are first subjected to a wet grindingto get to the liberation size. Laboratory work on the flota- TABLE Halite Pond Brine Composition (Moles/1000 moles H 2 O) OriginalBrine Summer End Brine Winter End Brine Na 2 0 2 41.5730.40 37.43 K 2 Cl 2 5.75 11.8013.50 Li 2 Cl 2 2.845.82 4.71 MgCl 2 5.36 11.00 9.21 MgSO 4 4.97 10.20 10.32H 3 B0 3 1.58 3.242.73Density (g/1) 1,226 1,264 1,258 TABLE 2 Average Composition of End Brinesand Salts in the Sylvinite Ponds Brine  moles/1000   Salt moles ki 2 0) (Weight %) Summer Winter   Summer Winter Na 2 Cl 2 15.8 17,0 NaC1 68.266.9 K 2 Cl 2 9.9 9.1 KCI 25.6 22.5 Li 2 CJ 2 12.2 9.5 Schoenite 10.4MgCl 2 23.0 21.0Kainite5.2 0.2 MgSO 4 19.615.3 KLiSO 4 H 3 B0 3 6.3 5.5 Density (g/1) 1,2891,286  380   Sixth International Symposium on Salt, 1983—Vol. II HARVESTED SALTS FROM SYLVINITE PONDS WET GRINDING FLOTATION   EAGENTS RINE TO,SA WATER FLOTATION CIRCUIT WASHING TANK CENTRIFUGES No CI BRINE DRYINGSCREENING Figure 2. Schematic flow diagram of potassium chloride productionCOARSE KCI STANDARD K CI
Similar documents
View more...
Related Search
We Need Your Support
Thank you for visiting our website and your interest in our free products and services. We are nonprofit website to share and download documents. To the running of this website, we need your help to support us.

Thanks to everyone for your continued support.

No, Thanks

We need your sign to support Project to invent "SMART AND CONTROLLABLE REFLECTIVE BALLOONS" to cover the Sun and Save Our Earth.

More details...

Sign Now!

We are very appreciated for your Prompt Action!